TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 373 of 933
TM 9-2520-270-34
31. REPLACE CONTROLLER ASSEMBLY (1).
RECORD FAILURE ON DA FORM 2407
AND RETURN CONTAMINATED
CONTROLLER TO DEPOT
32. EFFORT IS COMPLETE. GO TO
END OF TASK.
35. INSTALL CONTROLLER FLUID FILTER
ELEMENT ( 3 ) IF REMOVED.
a.
b.
c.
d.
Coat two new preformed packings ( 4 )
and o-ring ( 5 ) with transmission oil.
Install two new packings ( 4 ) on cap ( 6).
Install new o-ring ( 5 ) in top of
element ( 3).
Install element ( 3 ) on cap ( 6).
33. INSTALL PRESSURE FLUID FILTER ( 2).
See task, REPLACE PRESSURE FLUID
FILTER, page 3-42.
34. EFFORT IS COMPLETE. GO TO END OF
TASK.
36. INSTALL CAP (6) WITH ELEMENT
( 3) .
a. Push cap ( 6 ) with element ( 3.) into
cavity in controller assembly ( 1 ).
b. Aline four screw holes (7) in cap ( 6 )
with screw holes ( 8 ) in controller
assembly ( 1 ).
c.
Using plastic-faced hammer, tap and
seat cap ( 6 ) into place.
GO TO NEXT PAGE
Change
3
4-73
30. REMOVE CONTROLLER ASSEMBLY (1).
See task REPLACE CONTROLLER
ASSEMBLY, page 3-32.
ASSEMBLE
Back to Top
