TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 634 of 933

TM 9-2520-270-34

4. INSPECT TAPERED CONE AND

ROLLERS (1).

a. Inspect cone and rollers (1)

for damage. See TM 9-214

b. If cone and rollers (1) are damaged, go

to step 9. If not, go to step 5.

5.

INSPECT FOUR SPUR GEARS (2)

a.

b.

Inspect four gears (2) for damage. See

page 2-5.

If gears (2) are not damaged and

rotate freely, go to step 6. If gears

are damaged, or do not rotate freely,

go to step 9.

6. CHECK END PLAY OF GEARS (2).

a. If end play between thrust washers (3)

and gears (2) is less than ,060 inch

(1.52 mm), go to step 7, If not, go

to step 9.

7. TURN OUTPUT CARRIER (4) OVER.

8. INSPECT PLANETARY GEAR

SPINDLES (5) AND PINS (6).

a. If all spindles (5) and pins (6) are

tight, go to step 14. If not, go to step 10.

GO TO NEXT PAGE

4-305