TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 631 of 933

TM 9-2520-270-34

WARNING

Retaining ring is installed

under high tension. Use care

when removing and Installing

retaining ring. Personnel

can be Injured. Always wear

goggles.

34. REMOVE RETAINING RING (1).

a. Using retaining-ring pliers, remove

retaining ring (1).

36. CHECK GAP BETWEEN WASHER (2)

AND RETAINING RING (1).

a. If gap is 0.006 to 0.013 inch

(0.15 to 0.33 mm), go to step 38.

If not, go to step 37.

CAUTION

Do not scratch carrier shaft surface when

installing retaining ring. Equipment can be

damaged.

35. INSTALL NEW WASHER (2) AND

RETAINING RING (1).

a. Install washer (2) on shaft (3).

b. Using retaining-ring pliers, install

retaining ring (1) sharp-face up

in groove (4) on shaft (3).

37. REMOVE RETAINING RING (1) AND

WASHER (2).

a. Using retaining-ring pliers, remove

retaining ring (1).

b. Remove washer (2).

c. Go to step 21.

4-302

Change 2