TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 684 of 933
TM 9-2520-270-34
3. IF ANY BRAKE ACTUATING PLATE
INSERT (1) WAS REPLACED, GO
STEP 4. IF NOT, GO TO STEP 6.
4. TURN PLATE (2) OVER.
a. Inspect back of plate (3) where
insert(s) (1) was installed.
TO
new
b. If insert(s) (1) caused back of plate (3)
to deform, go to step 5. If not, go to
step 6.
5. HONE RAISED AREA (4) OF
PLATE (2).
a. Using fine honing stone, hone raised
area(s) (4) on bottom of plate (2) until
surface is flat.
6. CLEAN ALL INSERTS AND RELATED
HOUSINGS.
a. Clean assembly and hardware. See
page 2-2.
END OF TASK
Change 1
4-351
Back to Top
