TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 676 of 933

TM 9-2520-270-34

35. CHECK GAP BETWEEN WASHER (1)

AND RETAINING RING (2).

a. If gap is 0.006 to 0.013 inch

(0.15 to 0.33 mm), go to step 37.

If not, go to step 36.

37. INSTALL SEAL (3).

a. Install new gasket (4).

b. Install seal (3) on shaft (5) with

beveled end (6) toward housing (7).

36.

REMOVE RETAINING RING (2)

AND WASHER (1).

a. Using retaining-ring pliers, remove

retaining ring (2).

b. Remove washer (1).

c. Go to step 20.

38. INSTALL EIGHT SCREWS (8).

a. Using 3/8-inch drive ratchet handle

with extension and 7/16-inch socket,

install eight new lock washers (9)

and screws (8).

39. USING 3/8-lNCH DRIVE TORQUE

WRENCH WITH EXTENSION AND

7/16-lNCH SOCKET, TORQUE EIGHT

SCREWS (8) TO 75-100 in-lb

(86-115 cmkg).

40. INSTALL LEFT-HAND OUTPUT

HOUSING. See task REPLACE

LEFT-HAND OUTPUT HOUSING,

page 4-314.

END OF TASK

Change 2

4-344.1 (4-344.2 blank)