TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 673 of 933

TM 9-2520-270-34

NOTE

The object of these calculations is to find

washer thickness needed to get correct end-

play of carrier assembly in housing.

23. OBTAIN DIMENSION A.

a. Using depth gage, measure distance

from top of plate (1) to bottom of

splined hole (2).

b. Record results as dimension A

c. Remove plate (1).

25. PLACE OUTPUT HOUSING (5) ON

TWO WOOD BLOCKS (ITEM 4) SO

THAT BOTTOM OF CARRIER

ASSEMBLY (4) IS NOT TOUCHING

WORKBENCH.

24. REPAIRER AND HELPER REMOVE TWO

WOOD BLOCKS (3) FROM UNDER

CARRIER ASSEMBLY (4).

26. SEAT CONE AND ROLLERS (6)

IN HOUSING (5).

a.

Using plastic-faced hammer, gently

tap carrier assembly (4) down until

cone and rollers (6) are fully

seated.

4-342

Change 2