TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 672 of 933
TM 9-2520-270-34
WARNING
Retaining ring is installed
under high tension. Use care
when removing and installing
retaining ring. Personnel can
be injured. Always wear
goggles.
CAUTION
Do not scratch carrier shaft surface when
installing retaining ring. Equipment can be
damaged.
20. INSTALL RETAINING RING (1)
ON CARRIER SHAFT (2).
a. Using retaining-ring pliers, install
retaining ring (1) sharp-face up in
grove (3) on carrier shaft (2).
21. SEAT CARRIER ASSEMBLY (4) IN
HOUSING (5).
a.
Using plastic-faced hammer, gently
tap output housing collar (6) down
to seat carrier assembly (4).
22. POSITION MEASURING PLATE (7)
ACROSS OUTPUT HOUSING
COLLAR (6).
a. Place plate (7) across output
housing collar (6).
b. Position plate (7) to cover half
of output carrier splined hole (8).
GO TO NEXT PAGE
Change 2
4-341
Back to Top
