TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 696 of 933

TM 9-2520-270-34

19. REMOVE TWO LOOP CLAMPS (1).

a. Using wire-twister pliers, remove

and discard two Iockwires (2).

b. Using 3/8-inch drive ratchet handle

and 5/32-inch socket wrench attach-

ment, remove screw (3), bolt (4), and

spacer (5). Discard screw and bolt.

c. Spread open and pull off two

clamps (1).

21. POSITION TRANSMISSION LEFT

SIDE UP.

WARNING

Hanging loads could kill or

injure you. Keep away from

hanging loads and overhead

equipment.

CAUTION

Do not contact hoses with hydraulic assem-

bly when lifting

from transmission.

Damage to equipment can occur.

NOTE

Race may be lifted by hand for removing two

screws that are close to main housing.

22. REPAIRER AND HELPER REMOVE LEFT-

HAND HYDRAULIC ASSEMBLY (9).

a.

b.

Remove one long bolt (10), seven short

bolts (11), and eight washers (12).

Attach lifting device (13) to removal

assembly (6) and lift out hydraulic

assembly (9).

20. ATTACH FIXTURE REMOVAL

ASSEMBLY (6).

a. Install two screws (7) in screw

holes (8) in hydraulic assembly (9).

b. Tighten two screws (7).

GO TO NEXT PAGE

4-363