TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 235 of 779

Remove

support is removed or installed in the same

1. Remove cotter pin, slotted nut (A), and bolt attaching

manner.

turbosupercharger mounting base support (B) to

Install

transmission adapter.

2. Remove support.

1. Position turbosupercharger mounting base support

(B) on transmission adapter.

Note.

Left turbosupercharger mounting base

2. Install bolt, slotted nut (A) and cotter pin securing

support.

Figure 5-81. Removing or installing right turbo supercharger

mounting base support.

5-9.

Throttle Control Rods and Lever,

Refer to Table 5-6

Fuel Injection

Pump Oil Inlet Hose ,

disassembly instructions.

Turbosupercharger Oil Inlet Hose and

listed

in the table.

Fire Extinguisher Tube, and Fuel ln-

jection Pump

Table 5-6. Throttle Control Rods and Lever, Fuel Injection Pump

Oil Inlet Hose, Turbosupercharger Oil Inlet Hose and

Fire Extinguisher Tube, and Fuel Injection Pump

for illustrations and

Figure references are

Component

Figure Reference

Throttle Control Rods and Intermediate Throttle Lever

5-82 through 5-84

Fuel Injection Pump Oil Inlet Hose

5-85 Through 5-87

Turbosupercharger Oil Inlet Hose and Fire Extinguisher

5-88 through 5-90

Tube

Fuel Injection Pump

5-91 through 5-96

5-49