TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 241 of 779

Remove

1. Remove self-locking nut (A) attaching two cushioned

loop clamps securing oil inlet hose and fire extinguisher

tube to front fan drive housing.

2. Remove self-locking nut (B) attaching two cushioned

loop clamps securing oil inlet hose and fire extinguisher

tube to rear fan drive housing.

3. Remove self-locking nut and machine screw (C)

attaching turbosupercharger oil inlet hose and fire

extinguisher tube clamps. Remove clamps.

4. Disconnect and remove turbosupercharger oil inlet

hose (D) from elbow in crankshaft damper and oil filter

housing.

5. Remove fire extinguisher tube (E) and clamps.

Remove two clamps from tube.

Install

1. Install two cushioned loop clamps on fire extinguisher

tube (E) and position tube in engine.

2. Position turbosupercharger oil inlet hose (D) in engine

and connect to elbow in crankshaft damper and oil filter

housing.

3. Position turbosupercharger oil inlet hose and fire

extinguisher tube clamps as shown. Install self-locking

nut and machine screw (C) securing clamps.

4. Position two cushioned loop clamps on fire ex-

tinguisher tube as shown and aline with clamp on oil

inlet hose. Install self-locking nut (B) securing clamp to

rear fan drive housing.

5. Install self-locking nut (A) securing clamps to front

fan drive housing.

Figure 5-90. Removing or installing turbo supercharger oil inlet hose and

fire extinguisher tube-engines with new tube and relocated clamps.

5-55