TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 244 of 779

5-10. Shrouds, Cylinder Deflectors and

Note.

Removal or installation of shrouds and

Nozzle and Holder Assemblies

cylinder deflectors is the same for both left and

Refer to Table 5-7 for illustrations and

right banks of the engine. For instructional

disassembly instructions. Figure references are

purposes, the right bank shrouds and cylinder

listed in the table.

deflectors are shown.

Table 5-7. Shrouds, Cylinder Deflectors, and Nozzle

Holder Assemblies

Component

Figure Reference

Shroud Pl ates and Cylinder Deflectors

5-97 through 5-102

Nozzle and Holder Assemblies

5-103

Remove

1. Remove two machine screws (A) attaching lower right

camshaft drive shroud.

2. Remove lower shroud (B).

3. Remove machine screw (C) attaching upper right

camshaft drive shroud.

4. Remove upper shroud (D).

Install

1. Position upper right camshaft drive shroud (D) on

engine.

2. Install machine screw (C) securing upper shroud.

3. Position lower right camshaft drive shroud (B) on

ermine.

4. Install two machine screws (A) securing lower shroud.

Disconnect

1. Remove four plate nuts (A) from lower right rear

engine shroud.

2. Remove machine screw (B) from shroud.

Connect

1. Install machine screw (B) in lower right rear engine

shroud.

2. Install four plate nuts (A) on shroud.

Figure 5-98. Disconnecting or connecting

lower right engine shroud-top view.

Figure 5-97. Removing or installing

camshaft drive shrouds-right side.

5-58