TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 252 of 779

Remove

1. Remove and discard camshaft gear housing cover

gasket (A).

2. Remove camshaft drive gearshaft oil transfer plug

retaining ring (B).

Install

1. Install camshaft drive gearshaft oil transfer plug

retaining ring (B).

2. Install a new camshaft gear housing cover gasket (A).

Figure 5-112. Removing or installing

camshaft drive gearshaft oil transfer

plug retaining ring.

1. Install mechanical puller (A) - 5120-678-5282 into

threaded end of camshaft drive gearshaft oil transfer

plug.

2. Remove oil transfer plug (B).

Figure 5-113. Removing camshaft drive

gearshaft oil transferplug using

mechanical puller-5120-678-5282.

1. Install mechanical puller (A) into threaded end of

camshaft drive shaft.

2. Remove camshaft drive shaft (B).

Figure 5-114. Removing camshaft drive shaft

using mechanical puller-5120-678-5282.

Disconnect

1. Loosen two hose clamps (A).

2. Remove two cap screws (B) and flat washers at-

taching camshaft gear housing to cylinder 6R.

Connect

1. Install two cap screws (B) and flat washers securing

camshaft gear housing to cylinder 6R.

2. Tighten two hose clamps (A).

Figure 5-115. Disconnecting or connecting

right camshaft gear housing at cylinder 6R.

5-66