TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 255 of 779

Remove

Install

1. Cut locking wire and remove two drilled head cap

1. Install two drilled head cap screws (A) and flat

screws (A) and flat washers attaching front fan drive

washers and install locking wire securing front fan drive

housing to mounting base.

housing to mounting base.

2. Note that two self-locking nuts were removed from

2. Two self-locking nuts at studs (B) will be installed

studs (B) when the double angle bracket was removed

when the double angle bracket is installed (fig. 5-84).

(fig. 5-84).

Figure 5-123. Removing or installing front fan drive housing

attaching parts.

5-69