TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 261 of 779

Remove

Install

1. Cut locking wire (A) securing eight bolts.

1. Install eight bolts (B) and flat washers securing oil

2. Remove eight bolts (B) and flat washers attaching oil

pan to rear of crankcase assembly.

pan to rear of crankcase assembly.

2. Install locking wire (A) securing bolts.

Figure 5-135. Removing or installing oil pan rear bolts.

Remove

2. Remove 27 of the 28 self-locking nuts (B) and flat

1. Cut locking wire and remove 12 drilled head bolts (A)

washers attaching oil pan to each side of crankcase

and flat washers attaching oil pan to crankshaft damper

assembly.

and oil filter housing.

install

1. Install 27 self-locking nuts (B) and flat washers

Note. One self-locking nut (B) and flat washer

securing oil pan to each side of crankcase assembly.

must remain on each side of oil pan until oil pan

2. Install 12 drilled head bolts (A) and flat washers

is removed to prevent oil pan from falling and

securing oil pan to crankshaft damper and oil filter

being damaged.

housing. Install locking wire securing bolts.

Figure 5-136. Removing or installing oil pan bolts-right front view.

5-75