TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 267 of 779

1. Attach a suitable lifting sling to top of cylinder

Note. Crankcase protector - 4910-795-7951 is

assembly using two 7 / 16 x 1-1 / 4 in. cap screws (A).

installed on cylinder pad before removin g

2. Carefully lift cylinder assembly until cylinder is just

cylinder assembly from piston. The protector

above piston pin bore (B).

3. Install crankcase protector - 4910-795-7951 on

will guard against damage to cylinder pad and

cylinder mounting pad studs and secure with two

mounting studs in the event connecting rod

cylinder base nuts (C).

should strike the pad as cylinder is lifted from

4. Remove cylinder assembly (D).

piston.

Figure 5-145. Removing cylinder No. lR.

5-81