TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 272 of 779

Remove

1. Remove oil pressure sending unit (A).

2. Remove low oil pressure warning switch (B).

3. Remove two cap screws (C), lock washers, and flat

washers attaching generator air intake tube front

support bracket to crankcase and remove bracket.

4. Remove two cap screws (D), lock washers, and flat

washers attaching rear support bracket to crankcase

and remove bracket.

Install

1. Position generator air intake tube rear support

bracket on crankcase and install two cap screws (D).

lock washers, and flat washers securing bracket to

crankcase.

2. Position front support bracket on crankcase and

install two cap screws (C), lock washers, and flat

washers securing bracket to crankcase.

Note.

It may be necessary to adjust the

bracket height when the generator air intake

tube is installed.

3. Install low oil pressure warning switch (B).

4. Install oil pressure sending unit (A).

Figure 5-150. Removing or installing oil pressure sending unit, oil

pressure warning switch and generator air intake tube

support brackets.

5-86