TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 278 of 779

Note.

Position flywheel to locate eye bolt hole

at top center.

1. Install three 9 / 16 x 1-3/4 in. bolts (A), used for

attaching transmission drive gearshaft assembly, as

puller screws into puller screw holes in flywheel

2. Alternately tighten bolts and pull flywheel (B) from

crankshaft dowel pins only far enough to permit in-

stallation of lifting eye bolt (C).

3. Install eye bolt - 5306-017-6143 and attach suitable

chain hoist. Continue tightening puller bolts to remove

flywheel from crankshaft dowel pins (fig. 5-162).

Figure 5-161. Preparing flywheel for removal.

Caution:

Use care in removing the flywheel

from the dowel pins so as not to bind the flywheel

on the pins.

1. Remove flywheel (A) from the two dowel pins in

flange on crankshaft.

2. Remove three puller bolts (B) from flywheel.

Figure.5-162. Removing flywheel using

eye bolt-5306-017-6143.

5-92