TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 280 of 779

Remove

1. Attach suitable chain hoist in transmission adapter

lifting eye (A).

2. Separate adapter (B) from studs, dowel pine, and

crankcase assembly. Remove adapter.

3. Remove and discard transmission adapter gasket (C).

Install

1. Position a new transmission adapter gasket (C) on

crankcase assembly.

2. Attach a suitable chain hoist in transmission adapter

lifting eye (A).

3. Position transmission adapter (B) on studs and dowel

pins in crankcase.

Figure 5-164. Removing or installing

transmission adapter.

Remove

1. Cut locking wire and remove three drilled head bolts

(A) attaching oil seal retainer to oil seal cap. Remove

retainer.

2. Cut locking wire and remove three drilled head bolts

(B) attaching oil seal retainer to oil seal housing.

Remove retainer.

Install

1. Position retainer on oil seal housing. Install three

drilled head bolts (B) securing retainer to housing and

install locking wire securing bolts.

2. Position retainer on oil seal cap. Install three drilled

head bolts (A) securing retainer to cap and install

locking wire securing bolts.

Figure 5-165. Removing or installing

crankshaft oil seal retainers.

5-94