TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 282 of 779

Remove

main bearing crankcase tie rod nuts before

1. Remove four cap screws (A) and flat washers at-

removing support. Refer to figure 5-171.

taching oil seal housing support (B) to crankcase

assembly.

Install

2. Remove support from dowel pins (fig. 5-169) in

1. Position oil seal housing support (B) on dowel pins

crankcase.

(fig. 5-169) in crankcase.

3. Remove and discard candlewick packing (C).

2. Install four cap screws (A) and flat washers securing

support to crankcase assembly.

Note.

It may be necessary to loosen No. 7

3. Install new candlewick packing (C).

Figure 5-168. Removing or installing oil seal housing support.

5-96