TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 285 of 779

Remove

1. Remove cotter pin, slotted nut (A), and plate washer

and remove upper tie rod at No. 7 main bearing, from

left side of crankcase assembly.

2. Remove lower No. 7 main bearing tie rod (B) slotted

nut and plate washer from opposite (right) side of

crankcase and remove tie rod.

3. Remove 12 cotter pins, tie rod slotted nuts (C), and

six plate washers from crankcase. Separate parts.

Install

1. Position 12 tie rods through crankcase and install six

plate washers, 12 slotted nuts (C), and cotter pins.

2. Position lower No. 7 main bearing tie rod (B) through

crankcase from opposite (right) side of crankcase and

install plate washer, slotted nut, and cotter pin.

3. Position upper tie rod at No. 7 main bearing through

crankcase and install plate washer, slotted nut (A) and

cotter pins.

Figure 5-172. Removing or installing tie rods and attaching

parts-left side view.

5-99