TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 249 of 779

Note.

The cylinder and valve rocker arm

covers are machined as an assembly. Each

rocker arm cover must be kept with its mating

cylinder to insure camshaft bearing alinement

and running clearance. Identifying numbers are

used to prevent mismating of parts.

Figure

5-105.

Location of valve rocker arm

cover and cylinder identifying marks.

Disconnect

1. Remove three cap screws (A) attaching right lifting

eye to rocker arm cover and cylinder No. 1R.

2. Remove three cap screws (B) attaching each in-

tercylinder hose flange to remaining covers and

cylinders on right side of engine. Slide flanges and

lifting eye away from rocker arm covers and cylinders.

Con nect

1. Slide intercylinder hose flanges and right lifting eye

against rocker arm covers and cylinders. Install three

cap screws (B) securing each hose flange to rocker arm

cover and cylinder on right side of engine.

2. Install three cap screws (A) securing lifting eye to

cover and cylinder No. lR.

Figure 5-106. Disconnecting or connecting

right front lifting eye and intercylinder

hose flanges.

5-63