TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 248 of 779

Remove

1. Remove 11 bolts (A) attaching eight injector tube

clamp supports to valve adjusting screw cover plates

and remove supports.

2. Remove 37 bolts (B) and flat washers attaching 24

valve adjusting screw cover plates to rocker arm covers.

Remove plates.

3. Remove and discard 24 cover plate gaskets (C).

Install

1. Position two new cover plate gaskets (C) on each of 12

rocker arm covers.

2. Position 24 valve adjusting screw cover plates on

rocker arm covers. Position eight injector tube clamp

supports on cover plates at locations shown and install

11 bolts (A) securing supports and plates to covers.

3. Install 37 bolts (B) and flat washers in remaining

locations securing cover plates to covers.

Figure 5-104. Removing or installing

valve

adjusting screw cover plates.

5-62