TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 389 of 779

Remove

1. Straighten tabs on two tab washers (A).

2. Remove two bolts (B) and tab washers. Discard tab

washers.

3. Remove pressure oil pickup funnel assembly (C).

4. Remove two magnetic drain plugs (D) and discard

plug gaskets.

Install

1. Position a new drain plug gasket on each magnetic

drain plug (D) and install plugs in oil pan.

2. Position pressure oil pick up funnel assembly (C) in oil

pan.

3. Install two bolts (B) and new tab washers (A).

4. Bend tabs on tab washers (A) securing bolts (B).

Figure 6-95. Removing or installing oil

pickup funnel assembly and magnetic drain

plugs, (M60 series vehicle application

engines).

Remove

1. Straighter tabs on two tab washers (A).

2. Remove two bolts (B) and tab washers. Discard tab

washers.

3. Remove pressure oil pickup funnel assembly (C).

4. Remove two magnetic drain plugs (D) and discard

plug gaskets.

Install

1. Position a new drain plug gasket on each drain plug

(D) and install plugs in oil pan.

2. Position pressure oil pickup funnel assembly (C).

3. Install two bolts (B) and new tab washers (A).

4. Bend tabs on tab washers(A) securing bolts(B).

Figure 6-96. Removing or installing oil

pickup funnel assembly and drain

plugs (universal vehicle

application engines).

6-9 5