TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 491 of 779

Remove

1. Remove eight self-locking nuts (A) attaching intake

manifold tubes for cylinder Nos. 3R and 4R to right

intake manifold.

2. Remove intake manifold tubes (B).

3. Remove and discard two intake manifold tube gaskets

(C).

Install

1. Position two new intake manifold tube gaskets (C) on

right intake manifold.

2. Position intake manifold tubes (B) for cylinder Nos.

3R and 4R on right intake manifold.

3. Install eight self-locking nuts (A) securing tubes to

manifold.

Figure 6-234. Removing or installing intak e

manifold tubes for cylinder Nos. 3R and 4R .

Remove

Note.

The right and left intake manifol d

elbows are identical. The position of the lef t

intake manifold elbow is 180 degrees opposit e

from the position of the right elbow .

1. Remove six seff-locking nuts (A) and flat washers.

2. Remove right intake manifold elbow (B) from right

intake manifold.

3. Remove and discard intake manifold elbow gasket

(c) .

Install

1. Position a new intake manifold elbow gasket (C) on

right intake manifold.

2. Position right intake manifold elbow (B) on right

intake manifold.

3. Install six self-locking nuts (A) and flat washers.

Figure 6-235. Removing or installing righ t

intake manifold elbow .

6-197