TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 518 of 779

Figure 7-9

1.

Install

eye

bolt-5306-017-6143

in

threaded

hole

provided in flywheel (A).

2. Attach suitable chain hoist eye bolt and aline dowel pin

holes in flywheel with dowel pins in crankshaft flange.

Position alined flywheel against flange on crankshaft.

3. Install three 9 / 16 x 1 ¾ in. bolts and alternately tighten

bolts to draw flywheel toward flange on crankshaft. Bolts

are used to secure transmission drive gearshaft.

Note.

Eye

bolt

-

must

be

removed from flywheel, before flywheel is drawn

tight against flange on crankshaft, to permi t

flywheel to clear transmission adapter lifting eye.

4. Remove lifting eye bolt and continue to tighten three

bolts until flywheel is tight against flange, then remove

bolts.

Figure 7-8. Installing flywheel using eye

bolt-5306-017-6143 .

7-6