TM-9-2815-200-35
ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)
TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
TM-9-2815-200-35 - Page 6 of 779
CAUTION / WARNING— Continued
Warning:
Use goggles, rubber gloves, and rubber apron when cleaning parts in
carbon removing compound. Provide adequate ventilation. Avoid inhalation of
fumes and skin contact. If compound is splashed on skin, flush with fresh water and
wash with alcohol, Alcohol containing 2 to 3 percent camphor is preferable.
(Paragraph 6-24a(1) )
Warning:
The valves and locks are under heavy spring tension. Exercise extreme
care when removing locks, retainers, and springs. (Figure 6-48 )
Caution:
Do not use an arbor press to remove ball bearings from drive cluster
gear. The gear is designed with a shoulder between the two bearings. (Figure 6-83)
Caution:
The piston oil cooling valve is a spring loaded assembly. Exercise care
when disassembling. (Figure 6-86 )
Warning:
The oil pressure regulator cover is spring loaded. Exercise care when
removing cover. (Figure 6-103)
Caution:
Do not attempt to remove the diaphragm drive coupler half from the
shaft using a standard puller as shown in figure 6-163. This may distort the coupler
and render it unserviceable. Use puller as shown. (Figure 6-165)
Caution:
Use extreme care in this operation to prevent damage to vane cover on
gearshaft. (Paragraph 6-42a(6) (c))
Warning:
Cleaning solvents and solvent cleaning compounds are toxic and
flammable and must be used only in a well ventilated room. Take adequate safe
guards for fire prevention in work area. Use protective clothing and avoid contact of
these solutions with the skin. (Paragraph 6-47c(3 ) )
Caution:
If lubricant is extended to face of washer nut, reliable retaining torque
cannot be obtained. (Figure 7-13)
Caution:
The fuel injector pump advance assembly must always be installed and
secured before operating test stand. (Paragraph 6-42, d., (4), (g) )
Caution:
Do not operate the starter motor continuously for more than one minute.
Allow a two-minute cool-off period before re-energizing the starter. (Paragraph 8-4c)
Back to Top
