TM-9-2815-200-35
ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)
TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
TM-9-2815-200-35 - Page 85 of 779
Disconnect
1. Remove adapter (A) from pump outlet.
Remove connector (B) from pump inlet.
2.
3. Remove four self-locking nuts (C) and flat washers
securing fuel pump to adapter.
Connect
1. Install four self-locking nuts (C) and flat washers
securing fuel pump to adapter.
2. Install connector (B) in pump inlet.
3. Install adapter (A) in pump outlet.
Remove
1. Remove fuel pump (A) from pump adapter.
2. Remove and discard mounting gasket (B).
Install
1. Position new mounting gasket (B) on studs.
2. Position fuel pump (A) on pump adapter.
Note.
When installing fuel pump make sur e
fuel pump shaft splines are properly alined with
drive coupling before securing pump to adapter .
Figure 4-3. Removing or installin g
fuel pump .
Figure 4-2. Disconnecting or connectin g
fuel pump .
Remove
1. Remove hexagon head cap screw (A) and clip securing
starter jumper lead to solenoid.
2. Remove large starter jumper lead clip from terminal
(B).
Install
1. Position large starter jumper lead clip on terminal (B).
2. Position jumper lead on solenoid lug and secure with
clip and hexagon head cap screw (A).
Figure 4-4. Removing or installing starte r
solenoid jumper lead .
4-3
Back to Top
