TM-9-2815-200-35
ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)
TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
TM-9-2815-200-35 - Page 90 of 779
Loosen
1. Slide boot back on generator far enough to expose the
mounting nut access openings (A).
2. Loosen, but do not remove, six self-locking nuts (B),
using box wrench -5120-789-4881 to permit rotation of
generator to align the large openings in the elongated
mounting slots.
Note.
In cases where boot is rigid, it may be
necessary to slide one side of boot back an d
loosen three mounting nuts, then repeat th e
procedure for the other three nuts. Do not cut or
otherwise mutilate boot .
Tighten
1. Position boot on generator just far enough so that the
mounting nut access openings (A) are exposed.
2. Tighten six self-locking nuts (B) using box wrench-
Remove
1. Rotate generator (A) counterclockwise until large
elongated openings in flange are alined with mounting
nuts, and remove generator and boot.
2. Remove boot (B) from generator.
Install
1. Position boot (B) on generator.
2. Position generator (A) so that large elongated
openings in flange are alined with mounting nuts, and
install generator and boot.
Figure 4-15. Removing or installin g
generator and boot .
Figure 4-14. Loosening or tightenin g
generator mounting nuts using bo x
wrench-5120-789-4881 .
4- 8
Back to Top
