TM-9-2815-200-35
ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)
TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
TM-9-2815-200-35 - Page 94 of 779
Remove
1. Remove two self-locking nuts and bolts (A).
2. Remove upper oil filler tube support bracket (B) from
bolt (relocated oil filler tube installation only).
3. Remove turbosupercharger end shroud (C).
Install
1.
Position
turbosupercharger
end
shroud
(C)
over
turbosupercharger.
2. Position upper oil filler tube support bracket (B) on
one bolt (A) relocated oil filler tube installation only).
3. Install two bolts (A) and self-locking nuts securing
end shroud. Bolt with support bracket must be installed
at top of shroud.
Figure 4-21. Removing or installing uppe r
oil filler tube support bracket an d
turbosupercharger
end
shroud.
Disconnect
1. Disconnect turbosupercharger oil inlet hose elbow
from nipple using open end wrench - 5120-448-0404
(A).
2. Remove self-locking nut and bolt (B) attaching inner
shroud plate to transmission oil cooler end shroud.
Connect
1. Install self-locking nut and bolt (B) securing inner
shroud plate to transmission oil cooler end shroud.
2. Connect turbosupercharger oil inlet hose elbow to
nipple using open end wrench - 5120-448-0404 (A).
Figure 4-22. Disconnecting or connectin g
turbosupercharger oil inlet hose elbow fro m
nipple using open end wrench -
4-12
Back to Top
