TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 323 of 856

INSTALLATION

1.

Insert fuel crossover tube (Figure 2, Item 15) into two elbows (Figure 2, Item 14) at front of cylinder heads.

Tighten nut on each elbow.

15

14

14

16

12

MAINT_151

Figure 2.

Fuel Line Installation.

2.

Connect hose assembly (Figure 1, Item 6) to outboard elbow (Figure 1, Item 7) in fuel pump

(Figure 1, Item 9). Tighten hose connection.

3.

Connect hose assembly (Figure 1, Item 5) to inboard elbow (Figure 1, Item 8) in fuel pump

(Figure 1, Item 9). Tighten hose connection.

4.

Connect hose assembly (Figure 1, Item 10) to tee (Figure 1, Item 11) in fuel inlet at rear of left cylinder

head. Tighten hose connection.

5.

If removed, install two clips (Figure 1, Item 13) on hose assembly (Figure 1, Item 12). Connect hose

assembly to tee (Figure 1, Item 11) in fuel inlet at rear of left cylinder head and to elbow (Figure 1, Item 16)

at front of right cylinder head. Tighten hose connections.

6.

If removed, install clip (Figure 1, Item 3) on hose assembly (Figure 1, Item 12).

7.

Install clip (Figure 1, Item 3), located on hose assembly (Figure 1, Item 12), new lockwasher

(Figure 1, Item 2), and screw (Figure 1, Item 1) in air inlet housing (Figure 1, Item 4). Torque screw to

16–20 lb-ft (22–27 N·m).

END OF TASK

TM 9-2815-205-24

0050

0050-3