TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 458 of 856
REMOVAL
1.
Install cylinder head lifting fixture (Figure 1, Item 6), two 7/16 nuts (Figure 1, Item 4), and two 7/16 flat
washers (Figure 1, Item 5) on exhaust manifold studs (Figure 1, Item 3) located at outboard side of
cylinder head.
2.
Attach a suitable lifting device to lifting fixture (Figure 1, Item 6) and apply a light tension.
3.
Remove two cylinder head bolts (Figure 1, Item 1) from inboard corners of cylinder head and install two
cylinder head guide studs (Figure 1, Item 2). Remove remaining six cylinder head bolts.
WARNING
Components of this engine are heavy and awkward to handle. Use correct lifting
procedures, indicated lifting devices, and/or assistance from other personnel. Failure to
comply may result in injury to personnel.
CAUTION
Place two-inch thick wooden blocks underneath ends of cylinder head before placing on
bench to protect cam followers and fuel injector tips from damage.
4.
Lift cylinder head assembly (Figure 1, Item 7) from cylinder block.
5
4
6
7
1
2
1
2
3
MAINT_200
Figure 1.
Cylinder Head Removal.
TM 9-2815-205-24
0073
0073-2
Back to Top
