TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 673 of 856
CLEANING
WARNING
Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only
in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe
vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure
to comply may result in injury, illness, or death to personnel.
Remove all gasket material from end plate and wash plate with cleaning solvent.
END OF TASK
INSPECTION-ACCEPTANCE AND REJECTION CRITERIA
1.
Check plate for nicks, dents, scratches, score marks, and warpage.
2.
Inspect screw inserts for cracks and damaged threads.
END OF TASK
ASSEMBLY
If screw inserts (Figure 1, Item 6) were removed, support end plate (Figure 1, Item 3) on flat surface and
press screw inserts into plate from front until insert seats on end plate.
END OF TASK
INSTALLATION
1.
Install new gasket (Figure 1, Item 4) on rear of cylinder block using gasket adhesive.
2.
Apply a coat of gasket adhesive to outer surface of gasket (Figure 1, Item 4).
3.
Align holes in end plate (Figure 1, Item 3) with dowels (Figure 1, Item 5) in cylinder block. Push end plate
against cylinder block.
4.
Install 10 new lockwashers (Figure 1, Item 2) and 10 screws (Figure 1, Item 1). Torque screws to
30–35 lb-ft (41–47 N·m).
5.
On all, except models 5063-5393 and 5063-539L, install special washer (Figure 1, Item 7) and screw
(Figure 1, Item 8) on left side of end plate. Torque screw to 71–75 lb-ft (96–102 N·m).
END OF TASK
TM 9-2815-205-24
0093
0093-3
Back to Top
