TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 310 of 968

TM 9-2815-210-34-2-2

4-27.

AIR PRESSURIZATION TUBES AND FITTINGS (ENGINE LDS-465-2).

a. Cleaning.

FRAME 1

WARNING

Dry cleaning solvent is flammable. Do not use near an

open flame. Keep a fire extinguisher nearby when

solvent is used. Use only in well-ventilated places.

Failure to do this may result in injury to personnel

and damage to equipment.

Eye shields must be worn when using compressed air.

Eye injury can occur if eye shields are not used.

CAUTION

1.

2.

Air pressurization tubes (1, 2 and 3) are copper tubes

covered with a nonmetallic sheath. Generator air inlet

tube assembly (4) is made of rubber. Do not clean

rubber generator air inlet tube assembly with dry

cleaning solvent or it will dry out and crack.

Clean inside of air pressurization tubes (1,

2 and 3) with brass wire probes.

Flush inside of air pressurization tubes (1, 2 and 3) with dry cleaning solvent.

Blow dry with compressed air.

Clean rubber generator air inlet tube assembly (4) with soapy water. Blow

dry inside of tube with compressed air.

GO TO FRAME 2

4-291