TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 307 of 968

.

TM 9-2815-210-34-2-2

FRAME 2

1.

2.

3.

4.

Lay breather valve housing (1) flat on workbench as shown.

Put diaphragm assembly (2) on breather valve housing (1), alining holes.

Threaded end of diaphragm needle (3) must face up. Valve end of

diaphragm needle must rest in valve seat (4).

Tap threaded end of diaphragm needle (3) lightly with a short brass hammer

to seat diaphragm needle to valve seat (4).

Put on diaphragm end cover (5) alining holes. Put in and tighten five

screws (6) and lockwashers (7).

GO TO FRAME 3

4-288