TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 308 of 968

TM 9-2815-210-34-2-2

FRAME 3

1.

2.

3.

4.

5.

Turn over breather valve housing (1) and lay it flat on workbench as shown.

Put diaphragm assembly (2) on breather valve housing (1), alining holes.

Threaded end of diaphragm needle (3) must face up. Valve end of diaphragm

must rest in valve seat (4).

Tap threaded end of diaphragm needle (3) lightly with a short brass hammer

to seat diaphragm needle to valve seat (4).

Put spring (5) over threaded end of needle valve (3).

Put breather valve spring housing (6) on breather valve housing (1), alining

holes.

Put in five screw; (7) and lockwashers (8).

GO TO FRAME 4

4-289