TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 397 of 968
TM 9-2815-210-34-2-2
4-37. FUEL INJECTOR TUBE ASSEMBLIES AND ATTACHING PARTS.
a .
Engine LDS-465-2.
(1) Cleaning.
FRAME 1
1.
2.
3.
Slide six
WARNING
Dry cleaning solvent is flammable. Do not use near an
open flame.
Keep a fire extinguisher nearby when sol-
vent is used. Use only in well-ventilated places.
Failure to do this may result in injury to personnel
and damage to equipment.
CAUTION
Do not let dry cleaning solvent touch six rubber
boots (1).
Boots will dry out and crack. If dry
cleaning solvent splashes on rubber boots, dry with
clean cloth.
rubber boots (1) to one end of six fuel injector tubes (2). Clean
outside of six fuel injector tubes with dry cleaning-solvent. Dry with clean
cloth .
Slide six rubber boots (1) to center of six fuel injector tubes (2). Clean
the ends of six fuel injector tubes which were covered by rubber boots in
step 1.
WARNING
Eye shields must be worn when using compressed air.
Eye injury can occur if eye shields are not used.
Flush inside of six fuel injector tubes (2) with dry cleaning solvent. Blow
dry with compressed air.
-
Plug ends of six fuel injector tubes to keep out
dirt.
END OF TASK
TA 118495
4-378
Back to Top
