TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 401 of 968

TM 9-2815-210-34-2-2

b .

All Engines Except LDS-465-2.

(1) Cleaning.

FRAME 1

WARNING

1.

2.

3.

GO

Dry cleaning solvent is flammable. Do not use near

an open flame.

Keep a fire extinguisher nearby when

solvent is used.

Use only in well-ventilated places.

Failure to do this may result in injury to personnel

and damage to equipment.

CAUTION

Do not let dry cleaning solvent touch six rubber

boots (1).

Boots will dry out and crack. If dry

cleaning solvent splashes on

with clean cloth.

Slide six rubber boots (1) to one end

outside of six fuel injector tubes with

cloth.

rubber boots, dry

of six fuel injector tubes (2). Clean

dry cleaning solvent. Dry with clean

Slide six rubber boots (1) to center of six fuel injector tubes (2). Clean

ends of six fuel injector tubes which were covered by rubber boots in step 1.

WARNING

Eye shields must be worn when using compressed air.

Eye injury can occur if eye shields are not used.

Flush inside of six fuel injector tubes (2) with dry cleaning solvent. Blow dry

with compressed air.

Plug ends of six fuel injector tubes to keep out dirt.

TO FRAME 2

4-382