TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 469 of 968

TM 9-2815-210-34-2-2

FRAME 3

1.

2.

3.

4.

5.

6.

7.

NOTE

Readings must be within limits given in table 4-62.

The letter T shows a tight fit. If readings are not

within given limits, throw away part and get a new one.

Measure diameter of four retaining pins (1).

Measure inside diameter of four retaining pin bores (2) in pulley (3).

Measure fit of retaining pin (1) to bore in pulley (3). If fit is not within

given limits, throw away item with the most wear and get a new one.

Measure inside diameter of bore (4) in pulley (5).

Measure outside diameter of four sleeve bearings (6).

Measure inside diameter of four sleeve bearings (6) in pulley (5).

Measure fit of retaining pin (1) in sleeve bearing (6). If fit is not within given

limits, throw away item with the most wear and get a new one.

—

GO TO FRAME 4

4-450