TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 467 of 968

TM 9-2815-210-34-2-2

(2) Cleaning.

There are no special cleaning procedures needed. Refer to

cleaning procedures given in para 4-3.

(3) Inspection and repair.

NOTE

For engines LD-465-1, LD-465-1C, LDT-465-1C,

LDS-465-1, and LDS-465-1A, go to frame 1. For

engine LDS-465-2, go to frame 2.

FRAME 1

WARNING

1.

2.

3.

4.

5.

6.

7.

Dry cleaning solvent is flammable. Do not use near an

open flame.

Keep a fire extinguisher nearby when sol-

vent is used.

Use only in well-ventilated places.

Failure to do this may result in injury to personnel and

damage to equipment.

Check that pulley flange (1) and pulley half (2) has no cracks, nicks, wear

and other damage.

Fix minor damage to belt surfaces of pulley flange and

pulley half with fine mill file or crocus cloth dipped in dry cleaning solvent.

Check that clamping sections (3) of pulley flange (1) have no breaks and

bends.

Check that threaded holes in clamping section (3) are not damaged. Fix

damaged threads with a tap.

Check that two screws (4) have no damaged threads. Fix minor thread damage

with a file thread restorer.

Check that threads on pulley half (2) are not damaged. Fix damaged threads

with a file thread restorer.

Check that keyway inside pulley half (2) has no damage or wear.

If pulley flange (1) or pulley half (2) are damaged beyond repair, throw them

away and get new ones.

END OF TASK

4-448