TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 769 of 968

TM 9-2815-210-34-2-2

FRAME 2

1.

2.

3.

4.

5.

END

On some

to water

engines,

NOTE

engines, oil cooler water inlet tube (1) is joined

pump (2) with mounting flange (3). On other

- -

oil cooler water inlet tube is joined to water pump

with hose (4) and clamp (5).

If working on engine with mounting flange (3), do steps

.1, 2, and 3. If working on engine without mounting flange

(3), do steps 4 and 5.

For engines with mounting flange (3), put water inlet tube (1) in place. Slide

hose (6) onto oil cooler water inlet (7).

Put gasket (8) in place on water pump (2). Aline flange (3) and put in four

screws with nuts and lockwashers (9).

Tighten two hose clamps (5).

For engines without mounting flange (3), put

Slide hose (6) onto oil cooler water inlet (7).

Slide hose (4) onto water pump (2). Tighten

OF TASK

water inlet tube (1) in place.

four hose clamps (5).

5-140