TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 760 of 968

TM 9-2815-210-34-2-2

FRAME 4

1.

2.

3.

4.

5.

6.

Put flame heater gasket (1) in place.

Put flame heater elbow (2) in place.

NOTE

On some engines, ignition coil (3) may be mounted on top

of engine instead of next to flame heater elbow as shown.

Put ignition coil (3) with two clamps (4) in place.

Put on four nuts with lockwashers (5).

Screw in spark plug (6) with gasket (7).

Tighten spark plug to 8 pound-

inches.

Screw in nozzle and check valve assembly (8) with locknut (9). Tighten

locknut.

CAUTION

Do not use open end wrench to put on tube adapters (10).

Use tubing wrench or box wrench or equipment may be

damaged.

Put on two tube adapters (10).

GO TO FRAME 5

5-131