TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 765 of 968

TM 9-2815-210-34-2-2

5-25. AIR COMPRESSOR.

a.

All Engines Except LDS-465-2.

FRAME 1

1.

2.

3.

Put air compressor gasket (1) in place.

Put air compressor (2) in place. Put

on four nuts with lockwashers (3) and tighten nuts to 25 pound-feet.

Loosen two screws with lockwashers (4).

Using pulley adjusting wrench (5),

turn pulley half (6) to the left and take it off.

NOTE

Refer to TM 9-2320-211-20 for correct drive belt tension.

Hold compressor drive belt (7) while turning pulley half

(6) until drive belt moves out to bevel surface of pulley

half.

Put on drive belt (7) and put on pulley half (6). Using pulley adjusting

wrench (5), tighten pulley half until drive belt tension is correct. Put in

two screws with lockwashers (4).

END OF TASK

5-136