TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 423 of 736

TM 9-2815-225-34&P

0046 00

0046 00-11/12 blank

REMOVING ENGINE FROM MAINTENANCE STAND (Contd)

33.

Install new gasket (45), and oil level dipstick tube and cover (38) on cylinder block (46) with four

washers (44) and captive washer screws (43). Tighten captive washer screws (43) 30–35 lb-ft

(41–48 N

•

m).

34.

Install tube brace (33) and clamp (42) on oil level dipstick tube and cover (38) with two washers

(41), screw (36), new lockwasher (40), and nut (39). Tighten nut (39).

35.

Install tube brace (33) on cylinder block (46) with screw (36), washer (34), and new lockwasher (35).

NOTE

Perform step 36 for Big Cam I only.

36.

Install transmission control-body heating elements ON/OFF switch (47) on cylinder block (46).

37.

Install oil pressure gauge sending unit (48) and low oil pressure warning light sending unit (49)

on cylinder block (46).

END OF WORK PACKAGE

Figure 8. Oil Level Dipstick Tube Installation.

Figure 9. Oil Pressure Gauge Sensing Unit Installation.

45

36

41

33

34

35

37

36

38

39

40

46

41

42

43

44

47

46

48

49