TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 418 of 736

TM 9-2815-225-34&P

0046 00

0046 00-6

REMOVING ENGINE FROM MAINTENANCE STAND (Contd)

NOTE

Perform steps 11 through 13 on Big Cam I only.

11.

Install oil cooler (11) and new gasket (8) on cylinder block (1) with five screws (6) and (10), and

five new lockwashers (7) and (9). Tighten screws (6) and (10) 30–35 lb-ft (41–48 N

•

m).

12.

Install oil transfer hose (2) on oil cooler (11) with clamp (3). Tighten clamp (3) at water transfer

hose (2).

13.

Install oil cooler support bracket (5) to cylinder block (1) with screw (12) and new lockwasher (4).

Tighten screw (12) 30–35 lb-ft (41–48 N

•

m).

NOTE

Perform steps 14 and 15 on Big Cam III only.

14.

Install oil cooler (19) and new gasket (13) on cylinder block (1) with six screws (15) and (16), washers

(18), and new lockwashers (14) and (17). Tighten screws (15) and (16) 30–35 lb-ft (41–48 N

•

m).

15.

Install the following components on cylinder block (1). Refer to TM 9-2320-273-20 or

TM 9-2320-283-20.

a.

Engine oil filter elements

b.

Lower water transfer tube

c.

Alcohol evaporator

d.

Engine retarder microswitch

e.

Water manifolds

f.

Thermostat and thermostat housing

g.

Engine temperature sending units and fuel line fittings.

h.

Fan clutch air valve and air lines

i.

Water transfer tube and bracket

j.

Air compressor cooling tube