TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 420 of 736
TM 9-2815-225-34&P
0046 00
0046 00-8
REMOVING ENGINE FROM MAINTENANCE STAND (Contd)
16.
Install three new gaskets (2) on cylinder block (1) with word OUT facing exhaust manifold (3) or (7).
NOTE
Perform steps 17 through 19 for Big Cam I only.
17.
Apply antiseize compound to threads of screws (10).
18.
Install exhaust manifold (3), two clamps (12), four new lockplates (11), and dowels (13) on cylinder
block (1) with four screws (10). Do not tighten screws (10).
19.
Install four new lockplates (4) on exhaust manifold (3) with four screws (6) and new lockwashers
(5). Tighten screws (6) and (10) alternately and evenly 15–20 lb-ft (20–27 N
•
m) and then 40–45
lb-ft (54–61 N
•
m).
NOTE
Perform step 20 on Big Cam III only.
20.
Apply antiseize compound to threads of screws (9).
21.
Install exhaust manifold (7) and spacer inserts (8) on cylinder block (1) with twelve screws (9).
Tighten screws (9) alternately and evenly 15–20 lb-ft (20–27 N
•
m) and then 40–45 lb-ft
(54–61 N
•
m).
22.
Install the following components on cylinder block (1). Refer to TM 9-2320-273-20 or
TM 9-2320-283-20.
a.
Water filter and bracket
b.
Water shutoff valves and hoses
Back to Top
