TM-9-2910-226-34

PUMP, FUEL, METERING AND DISTRIBUTING, ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

JUNE 1974

  TM-9-2910-226-34 - Page 117 of 208

(2) Refer to figure 3-112. Install fixture —
4910-870-2128 on injection pump housing (A) and in-
stall fixture in a vise. Position bearing retaining plate
(B) so CLW (clockwise) line is as shown, Install four
lockwashers (C) and machine screws (D). Tighten
screws and bend tabs of lockwashers over screw heads
to secure screws.
Figure 3-112. Installing bearing retaining plate using fixture.
3-38. Installation of Quill Shaft
Assembly
a.
Position camshaft as shown in figure 3-113, before
installing quill shaft assembly.
TM 9-2910-226-34
Figure 3-113. Positioning camshaft prior to installing
quill shaft assembly.
b.
Refer to figure 3-114. Install fixture —
4910-870-2131 as shown to lock camshaft and prevent
rotation
Figure 3-114. Locking camshaft to prevent rotation.
3-71


Back to Top