TM-9-2910-226-34

PUMP, FUEL, METERING AND DISTRIBUTING, ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

JUNE 1974

TM-9-2910-226-34 - Page 123 of 208

TM 9-2910-226-34

Figure 3-129. Positioning spider assembly on camshaft prior to

checking end play.

(6) Refer to figure 3-130. Install timing device

housing (A) and secure with two flat washers (B),

lockwashers (C), and machine screws (D). Torque

tighten machine screws to 17-20 foot-pounds.

Figure 3-130. Positioning timing device housing prior to checking

end play.

(7) Refer to figure 3-131. Mount a suitable dial

indicator (A) on fuel injection pump. Move spider

assembly (B) up and down and take indicator

reading to obtain end play. End play must be bet-

ween 0.003 and 0.018-inch, Remove timing device

housing (C) and previously assembled parts (4) and

(5) above).

NOTE

If end play is within the above limits, retain

end play spacer for future assembly. If end

play is less than 0.003-inch, install a thin-

ner end play spacer and recheck end play. If

end play is more than 0.018-inch, install a

thicker end play spacer and recheck end

play.

3-77