TM-9-2910-226-34

PUMP, FUEL, METERING AND DISTRIBUTING, ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

JUNE 1974

TM-9-2910-226-34 - Page 118 of 208

TM 9-2910-226-34

c.

Refer to figure 3-115. Insert quill shaft assembly.

Figure 3-115. Installing quill shaft assembly.

d.

Refer to figure 3-116. Install quill shaft assembly

so open tooth alines with housing mark (A), Install cop-

per gasket (B) and machine screw (C). Torque tighten

machine screw to 80-90 inch-pounds and secure with

locking wire.

e.

Refer to figure 3-117. Coat both sides of quill shaft

pad gasket with a thin coat of sealer, MIL-S-45180 or

equivalent. Install quill shaft pad gasket (A) and quill

shaft pad cover (B). Secure cover with two copper

gaskets (C) and machine screws (D). Torque tighten ma-

chine screws to 50-60 inch-pounds. Screws will be lock

wired at governor installation (para 3-43).

Figure 3-117. Installing quill shaft pad cover.

3-39. Installation of Tappet Assembly.

a. Assembly.

The tappet assembly was assembled

during repair (para 3-29).

NOTE

Refer to figure 3-118 for selection of tappet,

spring, and spring seat.

Figure 3-116. Installing quill shaft assembly in housing.

3-72

Change 2