MWO-5-2350-262-35-4

MWO 5--2350--262--35--4

4--29

SECTION IV INSTALLATION OF AFT MANIFOLD ASSEMBLY -- CONTINUED

4--15 INTERCONNECTION OF AFT MANIFOLD ASSEMBLY

NOTE

Steps a through i below apply to Figures 4--16 and 4--17. All numbered callouts apply to Figure 4--16.

Locate hydraulic components identified in following procedure and connect to aft manifold assembly

ports as indicated in Figures 4--16, 4--17, and Table 4--3. Figure 4--16 shows mounting on 1” (2.54 cm)

hull bottom with aft manifold assembly (3) mounted to vehicle hull with three locking screws,

B1821BH038C325L, (2) and three flat washers, 10910174--3, (1).

Where applicable, replace identification and destination tags (band markers) attached to hydraulic hoses

re--routed and/or relocated as part of modification. Band markers are contained in Underside Band

Marker Kit, 12496969.

Install two 90

swivel, MS51521A6, (6) on aft manifold assembly port 9B.

Install new hydraulic hose, 13214E2495--6, (9) between port 11 (side) of aft manifold assembly and port

11 (rear) of left main manifold.

Install new hydraulic hose, 13214E2501--11, (5) between port 9B of aft manifold assembly and port 9 of

#4 left rear actuator (rear suspension unit).

Install new --12 hydraulic hose, 13214E2486--2, (8) between port 2A of aft manifold assembly and port 2

of #3 left actuator. Rotate 45

fitting on port 2 of #4 rotary actuator as required for proper fit/connection.

Remove hose, band marker 13214E2495--1 and install hose, 13214E2495--7, (10) between port 11 (top)

of aft manifold assembly and port 11 of #4 left rear rotary actuator.

Remove hose, band marker 13214E2501--2 and install hose, 13214E2501--7, (4) between port 9 of aft

manifold assembly and port 9 of left main manifold (rear side).

Remove hose, band marker 13214E2486 and install hose, 13214E2486--3, (7) between port 2 of aft

manifold assembly and port 2 of #4 left rear actuator.

MWO-5-2350-262-35-4 - Page 132 of 207