MWO-5-2350-262-35-4

MWO 5--2350--262--35--4

5--2

SECTION I PREPARATION FOR MODIFICATION

WARNING

High pressure is present in the M9 hydraulic system. Do not disconnect any hydraulic

system component unless hydraulic system pressure has been relieved. Ensure each of

the hydraulic control levers is moved several times through all positions, and the

hydraulic tank dipstick is slowly loosened to release pressure. After hydraulic pressure

has been relieved, wait at least four (4) minutes before disconnecting any hose or fitting.

Failure to comply may result in severe injury to personnel.

WARNING

Ensure that vehicle power is off and battery disconnected. Remove all jewelry, such as

rings, dog tags, bracelets, etc. If jewelry or disconnected battery ground cable contacts

battery positive terminal, a direct short will result, causing instant heating of tools, tool

damage, battery damage, or battery explosion. Failure to comply may result in severe

injury or death.

CAUTION

All exposed electrical contacts and connectors should be capped, protected, or sealed to

prevent damage.

CAUTION

Cap or plug all oil ports and ends of hoses and tubes when oil hoses or tubes are

disconnected or removed to prevent contamination. Failure to comply may result in

damage to equipment.

NOTE

Drain oil and collect into suitable containers when hoses and tubes are disconnected or

removed.

If not previously accomplished, raise and lock apron in full--up (full--open) position per TM

5--2350--262--10.

If not previously accomplished, disconnect vehicle battery power per TM 5--2350--262--20--1, Battery

Cable Replacement, Negative Cables Disconnect.

MWO-5-2350-262-35-4 - Page 137 of 207